The Raptor™ Series: RAP8H (Click Here for Product Options)
Here it is - the RAP8™ in a single housing! This model allows easy wiring, one lens, and easier single-point mounting by utilizing a single body design. The extruded aluminum housing allows no convective airflow through the fixture – meaning no cold air is pulled across the lamps (which could lower lumen output); any suspended dirt/dust in the environment won’t be pulled through either – the RAP8H™, with our standard lens option, stays clean even in filthy environments. Use it for distribution centers, warehouses, ice arenas, gymnasiums, hangars, cold storage facilities, manufacturing and other highbay applications, in ambient temperatures from -20F (-30C) up to (using a 90C rated ballast) 150F (65C). UL/CUL Damp Location Listed.
Housing
It’s .060” anodized, extruded aluminum. We’ve added wings to the ballast channel, to increase the radiative mass for additional thermal transfer – keeping lamp heat from damaging the sensitive electronics in the ballast via our integral ballast heat-sink. The reflector assembly is unitized for easy access to the ballast/wiring compartment without removing lamps. 1/2" conduit entry hole in each end, top feed hole option available. Clear anodized standard finish, anodized colors available.
Electrical
The RAP8H™ uses 440 input Watts – 6% less than the competition. HF electronic programmed start, multi-volt ballasts. Specify 120-277V or 347-480V. Dimming is available, too, line-voltage, 0-10V, even DALI. Lots of multi-lamp control options via simple switchlegs! Seismic make-and-break captive rotor lamp sockets. Lamps are 85 CRI with .95 lumen maintenance over life, and are rated to 40,000 hours life at 12 hours per start.
Optics
95% reflective specular hard-anodized aluminum roll-formed engineered T5 reflector. Very uniform in the horizontal & vertical planes. Optional 0.125" clear acrylic or polycarbonate lens in captive, hinged/latched anodized aluminum door frame.
Mounting
The RAP8H™ is provided with two hanging tabs that will accept chain or cable, allowing suspension without penetrating the fixture body. Optional HD™ heavy-duty bolt-on mounting brackets install anywhere along the fixture body for a wide variety of mounting configurations. Other mounting options are available – such as our PFS (Power Feed Stem) option - we can match any existing mounting means!
Fixture Weight
RAP8H™ 4’-0” length: 22 lbs. 4 oz.
