Home

The Raptor™ Series:  RAP12    (Click Here for Product Options)

 

Yes, 12 T5HO lamps in one fixture! The RAP12TM double up two RAP6TM luminaires for a mega-punch of light. Just as in the "single wides", the design of the extruded aluminum housing allows no convective airflow through the fixture - meaning no cold air is pulled across the lamps (which could lower lumen output); any suspended dirt/dust in the environment won't be pulled through either - the RAP12TM, with our standard lens option, stays clean even in filthy environments. Used it for large arenas, hockey rinks, aircraft hangars, and other large highbay areas - replace those energy-sucking 1000W and 1500W MH highbays! - in ambient temperatures from -20F (-30C) up to (using a 90C rated ballast) 150F (65C). UL/CUL Damp Location Listed.

Housing
It's .060" anodized, extruded aluminum. The double-wide ballast channels and wings increase the radiative mass for additional thermal transfer - keeping lamp heat from damaging the sensitive electronics in the ballast, via our integral ballast heatsink. The reflector assembly is unitized for easy access to the ballast/wiring compartment without removing lamps. 1/2" conduit entry hole in each end, top feed hole option available.

Electrical
The RAP12TM uses 660 input Watts - 9% less than the competition. HF electronic programmed start, multi-volt ballasts. Specify 120-277V or 347-480V. Dimming is available, too, line-voltage, 0-10V, even DALI. Lots of multi-lamp control options via simple switchlegs! Seismic make-and-break captive rotor lamp sockets. Lamps are 85 CRI with .95 lumen maintenance over life, and are rated to 40,000 hours life at 12 hours per start.

Optics
95% reflective specular hard-anodized aluminum roll-formed engineering T5 reflector. Very uniform in the horizontal & vertical planes. Our uplight option uses dedicated, serarately-switchable up-lamps with specular reflectors and protective spread lens...not mere uplight holes in our reflectors (which affects downlight distribution, and allows that pesky convective airflow across the lamps). Optional 0.125" clear acrylic or polycarbonate lens in captive, hinged/latched anodized aluminum door frames.

Mounting
The RAP12TM is provided with four hanging tabs that will accept chain or cable, allowing suspension without penetrating the fixture body. Optional HDTM Heavy-duty bolt-on mounting brackets install anywhere along the fixture body for a wide variety of mounting configurations. Other mounting options are available - we can match any existing mounting means!

Fixture Weight
RAP12TM: 30 lbs. 8 oz.

Specification Sheet

IES File

Uplight IES File

The RAP12 Luminaire is two RAP6 units joined side-by-side. It is photometrically correct to insert two RAP6 photometric files side-by-side for calculation purposes. The insertion points of these two files should be spaced 14" on center.