 Cutsheet
IES file
Options available for RAP1
EM Battery Ballast
Operates 1 lamp at 1/3 output (1250 lumens) for 90 minutes - works in addition to standard ballast.
[EM]
|
Dimming Ballast
Specify control type & manufacturer for compatability.
[DM] |
Top Power Entry Hole
1/2" trade hole for power entry. Specify top center or 4" from end of fixture.
[HM]
|
Cordset
6'-0" 16/3 cordset with strain relief, installed
[CS] |
Modular Cable Whip
Specify manufacturer, model #, length, color, and circuit connection.
[MW] |
Through-wiring
14 AWG through-wiring, specify 1 or 2 circuit.
[TW] |
Continuous Row mounting
Spline-joint connection for continuous row mounting.
[CR] |
Powered Aircraft Cable Suspension Set
(2) 6'-0" cables, (2) adjustable cable grippers, (2) 5" canopies, & (1) white 18/3 x 6'-0" power cord. Consult factory for other configurations.
[ACP] |
 |
Flex Whip
6'-0" 3/8" flex conduit with 16/3 fill
[FW]
|
|
Features
A small profile T5 high-output fluorescent commercial surface or suspended luminaire robustly designed for maximum performance with minimum energy use in utility spaces, corridors, task lighting, and other commercial & industrial applications. With a near tool-less design the RAP1 ™ is ready to install right out of the box - even the lamp comes pre-installed. Multi-volt ballasts take the guesswork out of what to stock. Rated at 93 L/W (54 watt lamp), this product offers outstanding savings on installation and maintenance labor costs. UL/CUL listed.
Housing
Robust one-piece extruded aluminum housing with integral ballast heat-sink. Ballast/wiring compartment easily accessed from below. 0.04" aluminum end plates. 1/2" wiring holes in each endplate with closure plug. Clear anodized standard finish. Available in nominal 2, 3, 4, 5, and 8 foot lengths, as well as optional CR continuous row mounting.
Electrical
Ballasts are CBM certified HPF electronic programmed start, 0.99 power factor, <10% THD, UL/CSA listed, Type 1, Class P, 105V-305V, 50/60Hz. Lampholders are positive-lock, captive rotor type, UL listed. Lamps are 85 CRI with .96 lumen maintenance over life.
Optics
95% reflective hard-anodized specular Miro-4 aluminum roll-formed engineered reflector. Clear impact-modified, interior-linear-prismed snap-on DR acrylic lens.
Mounting
Fixture supplied with two Quick-clip ™ snap-on stainless steel seismic mounting clips which fit anywhere along fixture length and will support over 100 times the fixture weight.
Fixture Weights
4'-0" length: 4 lbs. 10 oz. 8'-0" length: 6 lbs. 2 oz.
Shipping
Shipped assembled & pre-lamped with unit installation package (Quick-clip™ T-bar gripper clips, conduit entry plug and warranty/instruction sheet).
|
